ISCAR Cutting Tools
 The PRE-THREAD DCT CHAMDRILL
 
  PRE-THREAD

In addition to standard drilling applications,the revolutionary self-clamping CHAMDRILL mechanism is an excellent solution for special drilling requirements. Pre-thread hole drilling is very popular in many industries. Available are drills designed for M8 to M24 ISO M standard pre-thread holes.

The new DCT drills carry two standard chamfering inserts designated AOMT 060204-45DT IC508, symmetrically mounted and cutting forces are balanced for optimal performance.
This feature is essential in through hole applications.

Counter boring may be performed, however it is limited to a 6 mm depth.

Unique Chamfering Inserts
The AOMT 060204-45DT IC508 chamfering inserts were designed for chamfering and counter boring on a wide range of materials with optimal chip formation. The insert has an IC08 submicron substrate
and is TiCN +TiN PVD coated.

New CHAMDRILL 6.8 mm Pocket Size
In order to be able to drill the pre-thread hole for the popular M8 thread size,a new 6.8 mm pocket was designed.This pocket can
carry a range of drilling heads from 6.8 to 7.49 mm.

Advantages
• Can be used on a wide range of workpiece materials.
• Can be used for blind, as well as through hole, applications.
• No vibrations during chamfering due to a balanced drill
  construction.
• 1.5 mm x 45º chamfer is possible when the recommended drilling   conditions.
• Provides diametric versatility – CHAMDRILL is capable of using a   range of drilling heads on each drill body.
This provides a substantial advantage for users who change drills for the same tap operation.The user may use the same DCT drill for
ISO “M” (coarse pitch thread) and for ISO “MF” (fine pitch thread).

Machining Recommendations
• Machining recommendations used for the standard CHAMDRILL
  drills apply also to the new DCT drills for both drilling and
  chamfering - note that the same conditions may be used for
  chamfering.
• In counter boring, reduce cutting data by 10%.
• In case of chip formation/evacuation problems please try
  the following recommendations in the order presented:
  - Reduce cutting data by 10%.
  - Increase internal coolant pressure.
  - Apply a pecking cycle.
• Before clamping a new drilling head, apply some oil in any
   CHAMDRILL pocket. This will reduce pocket wear and increase
   the number of indexing cycles.

Applications
• Shallow (up to 6 mm) countersink screw head applications.
• Can be used for both rotating and stationary applications.
• An excellent choice for applications requiring a 45 º chamfer.
• Replaces our special drills that were designed for pre-thread hole   applications in order to reduce cost and unnecessary handling. 		 
 
DCTChamdrill